HP ProCurve Series 6120 Blade Switches Advanced Traffic Management Guide

2-29
Static Virtual LANs (VLANs)
Configuring VLANs
For example:
Figure 2-18. Example of “Show VLAN” Listing (GVRP Enabled)
Displaying the VLAN Membership of One or More Ports.
Name: The default or specified name assigned to the VLAN. For
a static VLAN, the default name consists of VLAN-x where “x”
matches the VID assigned to that VLAN. For a dynamic VLAN,
the name consists of GVRP_x where “x” matches the applicable
VID.
Status:
Port-Based: Port-Based, static VLAN
Protocol: Protocol-Based, static VLAN
Dynamic: Port-Based, temporary VLAN learned through
GVRP (Refer to chapter 3, “GVRP” .)
Voice: Indicates whether a (port-based) VLAN is configured as
a voice VLAN. Refer to “Voice VLANs” on page 2-56.
Jumbo: Indicates whether a VLAN is configured for Jumbo
packets. For more on jumbos, refer to the chapter titled “Port
Traffic Controls” in the Management and Configuration Guide
for your switch.
When GVRP is disabled
(the default), Dynamic
VLANs do not exist on the
switch and do not appear
in this listing. (Refer to
chapter 3, “GVRP” .)