HP ProCurve Series 6120 Blade Switches Advanced Traffic Management Guide

6-23
Converged Enhanced Ethernet on the HP ProCurve 6120XG Switch
FIP Snooping
fip-snooping show command
Figure 6-13. Output Displaying fip-snooping show Command
These warning/error messages may appear when FIP Snooping is being con-
figured.
Only four FC-MAPs can be configured globally to the box. If the user tries to
configure a FC-MAP index less than 1 or greater than 4, the following error
message is displayed:
The FC-MAP index must be between 1 and 4
If the user tries to configure a FC-MAP which has already been configured on
the switch, the following error message is displayed:
An entry already exists with this FC-MAP.
By FC-BB5 standards, FC-MAP should be in the range 0xEFC00 - 0xEFCFF. If
the user tries to configure a FC-MAP outside this range, the following error
message is displayed:
The FC-MAP must be in the range EFC00-EFCFF.
If the user tries to remove the configured FC-MAP, the following log message
is logged and displayed:
Connections established using <fc-map> FC-MAP have been removed..
Syntax: show fip-snooping
Displays the fip-snooping configuration information.
Default Value: None
Dependency: None
FIP Snooping Information
FIP Snooping : Enabled
FC_MAP table
Index | FC-MAP
------+----------
1 | 0xEFC00 (default FC_MAP)
FCF_MAC table
Interface | FCF_MAC Address
----------+----------------
24 | 00059b-70f380