HP ProCurve Series 6120 Blade Switches Advanced Traffic Management Guide

6-22
Converged Enhanced Ethernet on the HP ProCurve 6120XG Switch
FIP Snooping
Getting Started
Execute these steps in order to configure FIP Snooping on the switch:
1. Configure CEE on the switch
2. Configure the FC-MAP
3. Configure the FCF Port
4. Enable FIP Snooping
These steps are described in detail below.
1. Configure CEE on the switch.
See “Getting Started” on page page 6-7. In addition, before FIP Snooping can
be configured, all traffic must be turned off.
2. Configure the FC-MAP
If you are using the default FC-MAP , skip to the next step. Otherwise, first
configure the FC-MAP.
The following show command is available at this point.
Syntax: fc-map <FC-MAP index> <FC-MAP>
no fc-map <FC-MAP index>
Used to configure FC-MAP. Configure Fibre Channel MAC Prefix
(FC-MAP) on the switch. Only four FC-MAPs can be configured
per switch.
Default Value: 0xEFC00
Dependency: None