HP ProCurve Series 6120 Blade Switches Advanced Traffic Management Guide

5-56
Quality of Service (QoS): Managing Bandwidth More Effectively
Differentiated Services Codepoint (DSCP) Mapping
using qos dscp-map < codepoint > priority < 0 - 7 >. (These policies are not in
effect unless you have either applied the policies to a QoS classifier or
configured QoS Type-of-Service to be in diff-services mode.)
Quickly Listing Non-Default Codepoint Settings
Table 5-9 lists the switch’s default codepoint/priority settings. If you change
the priority of any codepoint setting to a non-default value and then execute
write memory, the switch will list the non-default setting in the show config
display. For example, in the default configuration, the following codepoint
settings are true:
If you change all three settings to a priority of 3, and then execute
write memory,
the switch will reflect these changes in the show config listing:
Figure 5-25. Example of Show Config Listing with Non-Default Priority Settings in
the DSCP Table
Codepoint Default
Priority
af11 1
13 No-override
af13 2
ProCurve(config)# qos dscp-map af11 priority 3
ProCurve(config)# qos dscp-map 13 priority 3
ProCurve(config)# qos dscp-map af13 priority 3
ProCurve(config)# write memory
ProCurve(config)# show config
Startup configuration:
; J9146 Configuration Editor; Created on release W.14.XX
hostname “ProCurve”
time daylight-time-rule None
qos dscp-map af11 priority 3
qos dscp-map 13 priority 3
qos dscp-map af13 priority 3
.
.
.
Configure these three codepoints
with non-default priorities.
Show config lists the non
default codepoint settings.