HP ProCurve Series 6120 Blade Switches Advanced Traffic Management Guide

5-47
Quality of Service (QoS): Managing Bandwidth More Effectively
Using QoS Classifiers To Configure Quality of Service for Outbound Traffic
For example, suppose that you want to prioritize inbound traffic on the
following source-ports:
You would then execute the following commands to prioritize traffic received
on the above ports.
Figure 5-20. Configuring and Displaying Source-Port QoS Priorities
If you then decided to remove port A1 from QoS prioritization:
Syntax: no interface < port-list > qos
Disables use of the specified source-port(s) for QoS classi-
fier(s) and resets the priority for the specified source-port(s)
to
No-override.
Syntax: show qos port-priority
Lists the QoS port-priority classifiers with their priority
data.
Source-Port Priority
1 - 3 6
4 - 5 5
6 -7 3
ProCurve(config)# interface 1-3 qos priority 6
ProCurve(config)# interface 4-5 qos priority 5
ProCurve(config)# interface 6-7 qos priority 3
ProCurve(config)# show qos port-priority
Port priorities
Port Apply rule | DSCP Priority Radius Override
---- ----------- + ------ ----------- ---------------
1 Priority | 6 No-override
2 Priority | 6 No-override
3 Priority | 6 No-override
4 Priority | 5 No-override
5 Priority | 5 No-override
6 Priority | 3 No-override
7 Priority | 3 No-override
8 No-override | No-override No-override
9 No-override | No-override No-override
10 No-override | No-override No-override