HP StorageWorks Operator Control Panel Replacement Instructions (5697-6792, June 2007)

1
3
2
0142b
Figure 1 Removing the OCP
Installing t
he OCP
1. Slide the new OCP into the enclosure (1, Figure 2).
2. Close the OCP until the latch engages.
3. Install the
front panel, pressing it firmly into place.
NOTE:
After installing the OCP, the controller may have to upgr ade the
OCP firmware. Do not remove the OCP while this operation is in
progress. When the OCP is displaying the alternating Storage
System Name and WWID, the correct firmware has been loaded
on the OCP.
0143b
1
Figure 2 Installing the OCP
Verifying proper operation
After replacing the OCP, verify that it is operating properly:
1. Check the display. It will typically display the default in formation
which alternates between the Storage System Name and the World
Wide Name.
2. Press any push button. The Storage System Menu Tree should be
displayed.
Returning the failed component
Follo
w the return instructions provided with the new component.
Page 2