EMULEX EZPilot EVA Version 2.0 User Manual (5697-6961, July 2007)

EZPilot - Installation Section Page 7
to use EZPilot Manager. See the Command View EVA documentation for the steps necessary to
grant permission to another account.
After making your selections, click Next. The EVA is initialized and the VDS provider is installed.
Figure 6: The EZPilot Switch Setup dialog box (Single switch configuration. DHCP supported and enabled)
10. If you have not previously configured a switch, the EZPilot Switch Setup dialog box appears.
Enter the switch's name, IP address, subnet mask and gateway address. If DHCP is supported
and enabled, you can check Obtain network settings automatically. Click Next.
11. If there is another switch to configure, click Next Switch when prompted and enter the switch's
name, IP address, subnet mask and gateway address.
12. You are notified when the switches are configured. Click Continue.
13. The Installing HP MPIO screen appears. When the installation is complete, you are prompted to
restart Windows. Click OK. After Windows is restarted, you will be notified that the installation is
complete.
Note: The check box label in Figure 5 displays your account name. In the example, the
standard Windows Administrator account is being used to install EZPilot. The
Command View password will be the same password as the Windows Administrator
account.
Note: This process may take a minute.
Note: Configuring the switch’s network settings may take a minute.