Medical Archive Solutions User Guide

HPMA User Guide
186
HP Medical Archive
PATn RAID controller status; indicates the
status of the RAID monitoring and is not
an indicator of the status of the RAID
itself:
• 0=Online
• 1 = Offline
The letter n in the Attribute Code is an
indicator of which RAID, as some servers
are attached to multiple RAID units. The
monitoring module is used to report sta-
tistics on the RAID.
Under certain circumstances the
monitoring module can become
shut down or disconnected. Once
it is brought back up, it initializes
and rebuilds the array if necessary,
then goes into “Online” state
again.
Check the RAID monitoring serial
cable at the back of the server to
make sure it is connected properly.
If this problem persists for a
period of time, unplug the serial
cable from the back and plug it
back in.
If the RAID monitoring still does
not initialize, contact HP technical
support.
PBST FSG Backup result; whether the backup
was:
• 0 = Successful
• 1 = Failed
If the backup reports “Failed”,
ensure there are no coincident
HTTP alarms on LDR nodes and
that capacity remains on some
Storage Nodes. Backups are run
automatically each day, and
retained for two weeks.
PFAn Fan State; indicates the state of the
internal fan for the RAID:
• 0=OK
• 1 = Speed Low
• 2 = Speed High
• 3 = Stopped
• 4 = Failed
• 5 = Unavailable
The letter n in the Attribute Code is an
indicator of which RAID, as some servers
are attached to multiple RAID units.
If the fan state is anything other
than “OK” (0), check the fan in the
unit to ensure proper operation. If
it is functioning properly but this
alarm persists, contact HP techni-
cal support.
Attr.
Code
Description Recommended Action