HP StorageWorks disk enclosure backplane replacement instructions (533479-001, March 2009)

8. Reinstall the power supplies
9. Reinstall the enclosure into the rack, and attach the bezel ears.
10. If the disk drives were previously removed from the enclosure,
reinsert them.
11. Reattach the power, Ethernet, and Fibre Channel cables to the
enclosure components.
12. Press the power button on the power UID bezel (located at rear of
enclosure) and hold it down until power is applied to the disk
enclosure. If more disk enclosures are in your EVA array, power
them up the same way.
13. Press the power button on the power UID bezel of the controller
enclosure and hold it down until power is applied.
Verifying proper operation
NOTE:
Wait three minute after powering up the enclosure for the system
to check component status.
Verify the status LEDs of the disk drives as described in Table 1.
Page 4