HP 4400 Enterprise Virtual Array Expansion Rack Reference Guide (5697-2285, January 2013)

CAUTION: Follow industry-standard practices when handling hard drives. Internal storage media
can be damaged when drives are shaken, dropped, or roughly placed on a work surface. When
installing a hard drive, make sure it is fully seated in the drive bay. To remove a hard drive, press
the release button and pull the drive only slightly out of the enclosure. Then, to allow time for the
internal disk to stop rotating, wait approximately 10 seconds before completely removing the drive
from the enclosure.
1. Pull the bezel covers that are installed over the thumbscrews on the front of the enclosure
straight out (see Figure 10 (page 11)).
CAUTION: Do not disengage the top and rotate the bezel covers downward — this can
break the locking tabs that secure the covers to the enclosure.
Figure 10 Removing bezels from enclosure
2. Align the enclosure with the rails and slide it into the rack Figure 11 (page 11).
CAUTION: The chassis is back-heavy. Pick it up carefully to maintain your balance.
Figure 11 Slide disk enclosure onto rails
Install the enclosures 11