HP B-series Fabric OS 7.1.0c Release Notes (5697-2892, October 2013 - includes all 7.1.0x versions)

Table 9 Fabric OS 7.1.0 closed defects (continued)
SolutionClosed defect summary
Fixed in Fabric OS 7.1.0.The Brocade 5640 switch posts hundreds of LF and LOS
during firmware download and power on.
Fixed in Fabric OS 7.1.0.When configuring a user monitor with multiple offsets and
each offset has multiple values in the value list, the counts
are inaccurate.
Fixed in Fabric OS 7.1.0.The SFID and DFID fields in the output of Frame Viewer
(using framelog --show) may be incorrect.
Workaround prior to upgrade:Frame drops are encountered on 8 Gb/s platforms when
credit loss is detected.
Reseat the blade.
Fixed in Fabric OS 7.1.0.
Workaround prior to upgrade:With FCIP fast write enabled, the PI sends the incorrect
RXID after a check condition.
Disable FCIP Fast Write.
Fixed in Fabric OS 7.1.0.
Workaround prior to upgrade:I/O failures to Open Systems Tape Device occur on FCIP
Tunnel with FCIP fast write enabled.
Disable FCIP Fast Write.
Fixed in Fabric OS 7.1.0.
Fixed in Fabric OS 7.1.0.POST timeout takes over 60 seconds to complete on a
Brocade 5460.
Workaround prior to upgrade:FCIP OSTP encounters "File too large" errors when running
to a new tape device.
Disable FCIP OSTP Emulation or limit tunnel bandwidth to
less than 5 Gb/s with fewer than 5 FCIP Circuits.
Fixed in Fabric OS 7.1.0.
Fixed in Fabric OS 7.1.0.Switch experiences a panic during firmware download
and CPs lose HA Sync.
Fixed in Fabric OS 7.1.0.Monitor software cannot trigger on INFO message and
the severity level of the FSSM-1004 Info message is
upgraded to Warning.
Workaround prior to upgrade:OXID is being reused on the target side in fast write tape
pipelining and is causing failures.
Disable FCIP Open Systems tape pipelining.
Fixed in Fabric OS 7.1.0.
Workaround prior to upgrade:Open Systems Tape Read job failures occur while running
multiple tapes.
Disable FCIP tape read pipelining.
Fixed in Fabric OS 7.1.0.
Fixed in Fabric OS 7.1.0.Fabric OS/HP Encryption SAN Switch/Network Advisor
allow encryption container creation in the absence of a
related L2 zone.
Fixed in Fabric OS 7.1.0.Loop port comes up "In_Sync" after a port bounce.
Fixed in Fabric OS 7.1.0.The Brocade BR5470 will only negotiate to 4Gb.
Fixed in Fabric OS 7.1.0.There is inappropriate information in swSensorValue MIB
after switching off the power supply on an HP SN6000B
16Gb FC Switch.
Fixed in Fabric OS 7.1.0.Webtools SwitchView shows details for ports in other FIDs.
Fixed in Fabric OS 7.1.0.The perfresourceshow --installed command
output is inconsistent with the documentation.
58