HP StorageWorks EVA Virtualization Adapter administrator guide (5697-0177, October 2009)
Table Of Contents
- EVA Virtualization Adapter administrator guide
- Table of Contents
- 1 Overview of HP EVA Virtualization Adapter
- 2 Configuring SRM and the HP EVA disk array
- 3 Installing and removing HP EVA Virtualization Adapter
- 4 Failover and failback with SRM
- 5 Troubleshooting HP EVA Virtualization Adapter
- HP StorageWorks EVA disk arrays do not appear in Site Recovery Manager
- HP StorageWorks EVA Virtualization Adapter does not install
- Virtual machines do not start at recovery site after failover.
- Site Recovery Manager timeout failure in large array configurations
- Virtual machines do not start at recovery site during the test failover test.
- Error messages
- SRM log
- EVA log
- HP EVA Virtualizaton Error Messages
- 6 Reference
- Glossary
- Index
Pairing SRM sites
You should now pair the protected and recovery sites in SRM. For more information, see the VMware
Site Recovery Manager Administration Guide.
Configuring SRM to communicate with HP Command View
EVA
When the protected and recovery SRM servers have been paired, configure SRM to use HP EVA
Virtualization Adapter by configuring array managers. To configure SRM to communicate with HP
Command View EVA disk arrays, complete the following steps:
1. Click Configure on the summary tab.
EVA Virtualization Adapter administrator guide 15