EMULEX EZPilot EVA Version 2.0 User Manual (5697-6961, July 2007)

EZPilot - Installation Section Page 3
Installing EZPilot to Create a Windows Management Server
Prerequisites
• If older versions of Emulex, Brocade or HP StorageWorks software were previously installed on
the system you must remove them. Use the Windows Add/Remove Programs feature to remove
the software. If you are prompted to reinstall the Emulex HBA driver during EZPilot installation,
click Yes.
• To automatically obtain network settings for the switch during EZPilot installation, you must have
a DHCP server setup on the IP network and a switch with DHCP support that is enabled.
Otherwise, you must have an IP address available to assign to the switch and know the gateway
address and subnet mask.
Procedure
To create a management server:
1. Install the HBA(s) in the system. Refer to the HBA’s Installation Manual for instructions.
2. Insert the EZPilot CD into the system’s CD-ROM drive.
The EZPilot Installer verification window appears. The window closes automatically when the file
verification process is complete.
The EZPilot EVA Installer welcome page appears.
Figure 1: The EZPilot EVA Installer welcome page
3. Click Next. The EZPilot Installation Options dialog box appears.
Note: You must install one and only one management server.
Caution: Do not install the driver from the CD that shipped with the HBA. EZPilot will install the
necessary driver automatically.
Note: Verification may take several minutes.