HP 3PAR T-Class Installation and Deinstallation Guide

i. Verify the IP address information is correct. Type y and press ENTER.
Please verify the following:
IP Address: xxxx
Netmask: xxxx
Nodes: 0 2 3
Default route through gateway xxxx, via xxxx
Speed and duplex will be autonegotiated.
No NTP server.
Does this appear to be correct? [y/n] y
Updated netc configuration in the PR.
SIGHUP has been sent to the netc controller. The network configuration
should reach the new state momentarily.
16. At the conclusion, the following screen displays:
Out-Of-The-Box has completed.
Please continue with the SP moment of birth.
Exiting Out-Of-The-Box Experience...
If any unexpected alerts occur during OOTB, the alerts display. Resolve any alert issues before
proceeding.
Setting up the Service Processor
The service processor (SP) enables the service provider to locally and remotely monitor and service
the storage system.
Service Processor Moment of Birth
The Service Processor Moment of Birth script (SPMOB) sets up and configures the service processor.
NOTE: Before performing the SPMOB, always reference the HP 3PAR Installation Workbook for
details of customer network setting requirements.
NOTE: The SP 2.5.2 release does not support Policy Manager and Keystroke Recording. These
features should not be configured during SPMOB. If you require these features, you must rebuild
to SP 2.5.1 MU1.
98 Initializing the Storage System Software