HP 3PAR T-Class Installation and Deinstallation Guide

60R3-0C1G-60R3-2C1G-60R3-0C9G-70R3-0C1G
60RK-0C05-ATX2-3TAH-64LF-JG3X-WHMA-9QVW
8M56-BDH1-ZWW4-WHFA-LV83-4FTX-KJRX-ZZ8E
...
The following features will be enabled:
Domains (No expiration date)
Thin Provisioning (1024G) (No expiration date)
Virtual Copy (No expiration date)
Are these the expected changes? (yes/no) y License key successfully set.
If the license information is not correct, type c and press ENTER to continue with the system
setup. After completing the system setup, contact HP 3PAR Technical Support for assistance
to obtain the proper license keys.
14. If the customer wants the CIM-based management API enabled, type y, otherwise type n.
Support for CIM-based management API is disabled by default. It can be enabled
at this point.
Does the customer want this feature to be enabled (y/n)? ==>n
15. Complete the network configuration:
a. When prompted, type the number of IP addresses used by the system (usually 1) and
press ENTER.
b. Type the IP address and press ENTER.
c. Type the netmask and press ENTER.
d. Type the gateway IP address and press ENTER.
e. Specify the speed and duplex settings and press ENTER.
Please specify speed (1, 100, or 1000) and duplex (half or full), or auto to
use autonegotiation: auto
f. Type the NTP server IP address and press ENTER.
NOTE: If an NTP server IP address is not provided, use the SP IP address.
g. If you indicated more than one IP address in step 15, the setup script prompts you to
choose which nodes to use for each address. Note, <X Y Z> are node numbers (for
example: 023 for nodes 0, 2, and 3).
Enter config for IP #0
IP Address: <IPaddress>
Netmask: <netmask>
Nodes Using IP address: <X Y Z>
h. If the customer specifies disabling all non-encrypted ports, type yes, otherwise type no.
Disabling non-encrypted ports will disable SP event handling,
Recovery Manager for VMWare, SRA, and CLI connections with
default parameters. It should only be done if there is a strict
requirement for all connections to be encrypted.
Disable non-encrypted ports? no
Setting Up the Storage System 97