HP 3PAR T-Class Installation and Deinstallation Guide

Figure 65 Preventing Accidental Disconnection of the Main Power Cord (NEMA L6-30)
WARNING! The main power cords include safety features to prevent plugging them into
electrical circuits not compatible with the storage system. To prevent serious injury to people
and damage to equipment, do not override this feature by using outlet adapters, altering
power cords, or modifying power receptacle connectors.
WARNING! To avoid possible injury, damage to storage system equipment, and potential
loss of data, do not use the surplus power outlets in the system PDUs. Never use outlets in the
PDUs to power components that do not belong to the storage system or to power storage
system components residing in other cabinets.
To plug in a main power cord with an IEC 60309 receptacle connector, insert the receptacle
connector until it locks into place.
7. Replace the side panels (for a T800) or the 4U filler panel covering the lowest chassis bay at
the front of the storage system.
CAUTION: To prevent overheating, do not operate a system unless all chassis bays are filled
with components or sealed with filler panels.
Positioning the Storage System
Before powering on the storage system, replace the rear door of the cabinet and any side panels
removed during installation. Move the storage system to a permanent operating location.
CAUTION: To avoid potential damage to system equipment, do not adjust the positioning of a
storage system while it is powered on.
Replacing the Rear Door
To replace the rear door:
Positioning the Storage System 73