HP 3PAR T-Class Installation and Deinstallation Guide

Figure 64 Routing the Main Power Cords
NOTE: To route power cords through the upper access opening of the cabinet, it is first
necessary to remove one or both side panels as described in “Removing Side Panels”
(page 51).
6. Plug each of the main power cords into a dedicated single-phase 200-240 VAC 30-A grounded
electrical circuit.
To plug in a main power cord with a NEMA® L6-30 power receptacle connector, insert the
power receptacle connector into the electrical outlet and rotate the connector clockwise one
quarter turn (“Preventing Accidental Disconnection of the Main Power Cord (NEMA L6-30)”
(page 73)).
72 Checks and Setup before Powering On the Storage System