HP 3PAR T-Class Installation and Deinstallation Guide

4 Installing the Drive Magazines
This chapter describes how to install drive magazines after placing a system at the operating site.
CAUTION: To avoid damaging the system equipment, do not relocate or move the storage system
over uneven surfaces with the drive magazines installed.
NOTE: If the cabinet has locking fascias, first remove the fascias to access the bezel. See “Storage
System Fascias” (page 46).
NOTE: Before installing the drive magazines, see the HP 3PAR Systems Assurance Document for
additional information about the placement of drive magazines for your specific system
configuration.
Preparing to Install Drive Magazines
Before installing drive magazines you must remove all bezels from the cabinet.
• To remove a bezel, use the handle slots located on the sides of the bezel and pull with both
hands“Removing a Bezel” (page 56)
Figure 45 Removing a Bezel
WARNING! To prevent danger of electric shock and potential damage to equipment, verify all
power supplies and PDUs are set to the OFF position before connecting a main power cord.
Clear any electrostatic charge in the area of the installation.
To discharge any electrostatic buildup on your person, put on a wrist grounding strap, connect
the clip to an unpainted, metal component of the cabinet frame. Require that other personnel
participating in the installation do the same.
When possible, ground the cabinet by connecting at least one main power cord to the power
source at the operating site as described in Section (page 70).
56 Installing the Drive Magazines