HP 3PAR T-Class Installation and Deinstallation Guide

17. Execute the shownode command to verify that all nodes have joined the cluster.
cli% shownode
Control Data Cache
Node --Name--- -State- Master InCluster ---LED--- Mem(MB) Mem(MB) Available(%)
0 1000163-0 OK No Yes GreenBlnk 4096 6144 100
1 1000163-1 OK Yes Yes GreenBlnk 4096 6144 100
18. Execute the shutdownsys reboot command and enter yes to reboot the system.
When the system reboot is complete, reestablish an SPMAINT session to perform additional
CLI commands.
19. Reconnect the host and host cables if previously removed or shutdown.
20. Issue the checkhealth -svc -detail command to verify the system is healthy.
21. In the SP window, issue the exit command and select X to exit from the 3PAR Service
Processor Menu and to log out of the session.
22. Disconnect the serial cable from the maintenance PC and the red cross-over Ethernet cable
from the node and coil and replace the cable behind the SP. If applicable, reconnect the
customer's network cable and any other cables that may have been disconnected.
23. Close and lock the rear door.
Service Processor-to-Node Rescue 207