HP 3PAR T-Class Installation and Deinstallation Guide

9. In the HyperTerminal main window, click File and then click Properties.
The New Sessions Properties dialog box opens.
10. Click the Settings tab. From the Emulation list, select either ANSIor VT100 to set the session
emulation type, then click OK .
11. Enter your login ID and password to begin the maintenance procedures.
NOTE: If you do not have a login ID and password, contact HP 3PAR Technical Support for
assistance.
Serial Cable Pinouts
The following tables and diagrams illustrate the serial cable pinouts for the crossover DB9 female
serial to RJ45 adapter assembly (P/N 180–0055) and the straight-through DB9 female to RJ45
serial adapter (P/N 180–0059).
Crossover Adapter Assembly
The following table lists cable pinouts for the crossover DB9 female serial to RJ45 adapter assembly
(P/N 180–0055). This connector inserts into the COM port on the maintenance PC.
Table 29 Crossover DB9 Female Serial to RJ45 Serial Connector Pinouts
RJ45 PinDB9 (Female) PinColor
32Black
23Orange
55Green
Figure 115 (page 200) illustrates the pin locations and connections for the crossover DB9 female
serial to RJ45 adapter assembly (P/N 180–0055).
Figure 115 Crossover DB9 Female Serial to RJ45 Serial Connector Pinouts
Straight-Through Adapter
The following table lists c onnector pinouts for the straight-through DB9 to RJ45 adapter (P/N
180–0059). This connector inserts into the serial port on the service processor.
200 Connecting the Maintenance PC