HP 3PAR T-Class Installation and Deinstallation Guide

Figure 110 SecureCRT Window
3. In the Quick Connect dialog box that appears, select the ssh2 option from the Protocol list.
Type the IP address of the storage system in the Hostname box. Type your user ID in the
Username box, and then click Connect.
4. In the Enter Password dialog box, type your password and click OK.
NOTE: If you do not have a user ID and password, contact HP 3PAR Technical Support for
assistance.
Using a Serial Connection
To connect the maintenance PC to the service processor using HyperTerminal through a serial
connection:
1. Unlock the rear door of the cabinet. Open the door by unlatching the three latches located at
the top, center, and bottom of the door.
2. Locate the service processor. Attach the DB9 female serial adapter (P/N 180–0055), that is
at the free end of the blue Ethernet cable, to the Serial port (COM1) on your maintenance PC
(“Attaching the Blue Ethernet Cable” (page 199)). A standard Category 5 Ethernet cable with
the appropriate RJ–45 to DB9 adapters at each end should already be connected to the service
processor DB9 Serial port (“Wintec Service Processor Serial Port with Adapter” (page 199) or
“Supermicro Service Processor Serial Port with Adapter” (page 199) or “Supermicro II Service
Processor Serial Port with Adapter” (page 199)).
198 Connecting the Maintenance PC