HP 3PAR T-Class Installation and Deinstallation Guide

5. Replace the foam packing at the front of the container, then raise the ramp and secure the
latches (“Raising the Ramp to Close the Cabinet” (page 166)).
Figure 97 Raising the Ramp to Close the Cabinet
WARNING! To avoid possible injury or damage to equipment, you must use a pallet jack
or similar device to move the cabinet after loading it into the shipping container.
Packing the Storage System in the Type 2 Shipping Container
NOTE: Refer to “Unpacking the Cabinet” (page 42) for information about Type 2 shipping
containers.
1. With at least one person pushing from the rear of the cabinet and a second person guiding
the cabinet from the front, wheel the cabinet to the loading area.
2. Place a pink poly antistatic bag over the storage system. These bags come shipped inside the
wooden crate.
3. Locate the front of the shipping container (“The Front of the Shipping Container” (page 167))
and unlatch the four rotary latches that secure the front panel.
166 Deinstalling the Storage System