HP 3PAR T-Class Installation and Deinstallation Guide

1. Connect the maintenance PC to the service processor as described in “Connecting to the
Service Processor” (page 193).
2. If necessary, log into the service processor maintenance interface.
3. Select option 2 for Network Configuration and press ENTER.
4. Select option 3 for Firewall Manipulation and press ENTER.
5. Select option 3 for Alter Public network firewall rules and press ENTER.
6. Select option 1 for Add a new host and press ENTER.
7. Type the IP address or range of at least one management workstation to be added and press
ENTER.
2.4.3 Alter Public FW
3PAR Service Processor Menu
Transfer media: ethernet Transfer status: Ok
Alter public firewall rules
Enter Control-C at any time to abort this process
Please enter the IP address of the host to add
-OR -
enter a subnet to add
(x.x.x.x/maskbits 192.168.1.0/24)
-OR -
enter a range of addresses
(x.x.x.x-y 192.168.1.0-10)
It is wise to keep ranges small and use
subnet notation where possible. A large
range specification can be very time intensive
to manipulate.
Type QUIT to abort:
IP.address
>
8. Verify the address and then type y and press ENTER.
9. To add other management workstations, repeat step 6 through 8. When finished adding
workstations, type x and press ENTER.
10. Select option 1 for Display Firewall Status and press ENTER to confirm settings.
11. Type x and press ENTER to return to the SPMAINT main menu.
Exporting Test LUNs
For the final step in verifying the storage system installation, create two or three test LUNs and
confirm that the attached host or hosts can access them. After you have created the test LUNs and
verified the host can access them, notify the system administrator that the storage system is ready
for use.
NOTE: Before you can export test LUNs, it is necessary to determine the host Fibre Channel
connection types and set the appropriate port personas for all target ports, or ports that connect
to host computers. See the HP 3PAR Implementation Guides where appropriate.
Defining Hosts
In order to define hosts and set port personas, access the CLI shell on the service processor.
Exporting Test LUNs 151