HP 3PAR T-Class Installation and Deinstallation Guide

5. Verify the service processor outbound communication ability and that the service processor
can transfer files by clicking Support > SP Network Configuration Menu > Connection Portal
Control > Test CP Connection. See “Verifying the Service Processor’s Outbound Communication”
(page 150).
Figure 85 Verifying the Service Processor’s Outbound Communication
A new window opens displaying the communication details (“Viewing the Service Processor
Communication Details” (page 150)).
Figure 86 Viewing the Service Processor Communication Details
6. In the SPOCC window, click Logout to end the session.
Adding Workstations to the Public Firewall Rules
After verifying service processor connectivity, add the management workstation (host) IP address
to the service processor public firewall rules. This allows access to the service processor. For
example, you can use a management workstation to connect to the service processor in order to
stop or start external communications.
NOTE: It is also possible to perform the following procedure directly from the SPOCC interface
using the same menus and procedures indicated as follows. The screens may appear different from
the examples.
150 Initializing the Storage System Software