HP 3PAR T-Class Installation and Deinstallation Guide

6. After successfully adding the system (InServ), press ENTER to return to the SP menu.
Adding <static.ip.address> to firewall rules on interface eth0
If you see any Password: prompts during this process
it is an indication that the nodes in the InServ
have NOT been properly configured!! DO NOT CONTINUE
IF THIS IS THE CASE! Contact 3PAR technical support!
communicating with <static.ip.address> using base key...
base key ok
interrogating <static.ip.address> for version number...
Version 2.5.1.X reported on <static.ip.address>
retrieving system data for <static.ip.address> ...
3PAR system name <InServ Name> found for <static.ip.address>
SYSID <InServ Name> found for <static.ip.address>
serial number <InServ serial #>found for <static.ip.address>
Writing configuration file for <static.ip.address>...
verifying / adding cli service ids...
attempting to force current keys onto node...
replaced key on node 0 of cluster <InServ Name>
replaced key on node 0 of cluster <InServ Name> in altroot
replaced key on node 1 of cluster <InServ Name>
replaced key on node 1 of cluster <InServ Name> in altroot
Adding InServ to NTP configuration...
creating required file structures... adding InServ to SP database...
Config complete for <static.ip.address>..
Starting 'spcollect' tasks for InServ <InServ Name>
Starting 'spevent' task for InServ <InServ Name>
InServ add complete
Press <enter/return> to continue
Continue on to Verifying Service Processor Connectivity.
Verifying Service Processor Connectivity
After the service processor restarts following the SPMOB, verify service processor connectivity as
follows:
1. When the service processor finishes restarting, open a Web browser and use the maintenance
PC to communicate with the service processor through SPOCC. See “Logging in to SPOCC”
(page 195) for specific instructions.
2. Select option 1 for SP Control/Status.
3. Select option 13 for Display SP status.
4. Verify the global procedures spcollect and spevent are running and the spevent is
running for all configured clusters (storage systems) and press ENTER. If these global events
are not running, contact HP 3PAR Technical Support for assistance. See “Verifying the SP
Status” (page 149).
148 Initializing the Storage System Software