Manualshelf

HP 3PAR T-Class Installation and Deinstallation Guide

ManualsBrandsHP ManualsStorageHP 3PAR T400 Configuration Base
141142143144145146147148149150
The SP firewall protects the SP and the customer
network from unauthorized use. It can be
configured in 'permissive' mode to allow
any host to connect to the SP via SSH and HTTP.
Do you wish to configure the SP firewall
in 'permissive' mode? [yes/NO]
yes
NOTE: Configuring the SP firewall in permissive mode enables access to the SP from any
host on the local area network.
17. Type yes to verify the supplied network information and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
The Host Name is: <spname>
- Public IP address: <static.IP.address>
- Netmask: <subnet.mask.address>
- Gateway: <default.gateway.address>
PERMISSIVE FIREWALL MODE SELECTED
NTP Server address:
Data Transfer media: ETHERNET
Remote Operations not allowed
Connection Portal: 3PAR default portal
Is this data correct? (yes or no)? [yes]
yes
18. Set up the time zone for the operating site:
a. Select a country from the list, type the corresponding number <X> , and press ENTER.
b. Select a continent or ocean from the list, type the corresponding number <X> , and press
ENTER.
c. Select a country from the region list, type the corresponding number <X> , and press
ENTER
19. Verify the time zone setting is correct, type 1 and press ENTER. Choosing option 2 restarts the
time zone configuration.
NOTE: The system automatically makes the time zone change permanent. Disregard the
instructions on the screen for appending the command to make the time zone change
permanent.
20. Press ENTER to accept the default date in brackets, or type the current date in MM/DD/YYYYY
format and press ENTER.
21. Type the current time in HH:MMformat or press ENTER to accept the default time indicated by
the installation script.
22. Typeyes to verify the indicated date and press ENTER.
23. Select the default SSH site keys.
Using the DEFAULT, installed Site key files:
If this is the INITIAL INSTALLATION of this 3PAR SP
and InServ at this site, the DEFAULT keys should be used.
Setting up the Service Processor 143