HP 3PAR T-Class Installation and Deinstallation Guide

Will this SP be allowed to be remotely controlled(yes or no)? [yes]
(Replying 'yes' will allow Remote Operations sessions from a Connection
Portal)
no
13. Type no to not use the HP 3PAR Connection Portal and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Will this SP use the 3PAR Connection Portal? ( yes or no ) [yes]
14. Answer the prompts about your proxy server.
SP Network Parameters
Enter Control-C at any time to abort this process
Does the connection to the CP require proxy services? (yes or no) [no]
yes
Please enter the name of the proxy server -OR- quit to abort setting a proxy
<proxy.server.name>
Please enter the IP address of the proxy server -OR- quit to abort setting
a proxy
<proxy.server.address>
Please enter the protocol supported by the proxy server from the list
HTTP
SOCKS4
SOCKS5
-OR-
quit to abort setting a proxy
SOCKS5
Please enter the port to contact on the proxy server [1080]
-OR-
quit to abort setting a proxy
15. Enter the IP address of your NTP server (if applicable). If an NTP server is not required, type
none and press ENTER.
Network Time Server
Enter Control-C at any time to abort this process
Please enter the I/P address of an external NTP server,
or a blank delimited list if more than one is desired,
or 'none' if there will not be any time server [?]:
Enter the IP address of an external NTP server
<NTP.server.address>
16. Type yes to configure the service processor firewall in permissive mode and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
142 Initializing the Storage System Software