HP 3PAR T-Class Installation and Deinstallation Guide

6. Type No to retain the current value or enter the current value of the Service Processor ID (SPID)
if applicable and press ENTER.
Do you need to change the Service Processor Id (SPID)
from its current value of SPXXXXX?
(y or n)
n
7. Accept the default service processor name (in brackets) by pressing ENTER, or type an alternate
name and press ENTER. The default service processor name is the SPID. Accepting the default
name is recommended.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the host name [SPXXXXX]:
[enter]
8. Type the static IP address assigned to the service processor and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the IP address for the public network interface:
<static.IP.address>
9. Press ENTER to accept the default subnet mask, or type an alternate subnet mask for the service
processor and press ENTER.
Please enter the netmask for this interface [255.255.255.0]:
<subnet.mask.address>
10. Press ENTER to accept the default gateway address shown in brackets, or type a default
gateway address and press ENTER. The setup script suggests a default gateway address based
upon the supplied IP address.
Please enter the IP address of a default gateway, or NONE [<static.IP.address.1>]:
<default.gateway.address>
11. Type yes to allow inbound and/or outbound files transfers and press ENTER.
Will this ethernet interface be used for inbound and/or
outbound file transfers (yes or no)? [yes]
12. Type no to not allow the service processor to be remotely controlled and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Setting up the Service Processor 141