HP 3PAR T-Class Installation and Deinstallation Guide

Are you ready to configure the SP at this time? (yes or no) [yes]:
[enter]
3. Type yes to indicate the site is secured and press ENTER.
CAUTION: If you answer yes, the service processor will not be able to communicate with
HP Central. A complete rebuild of the SP is required if the SP needs to establish communication
link with HP Central.
Site Security Level
Enter Control-C at any time to abort this process
A Secure Site is a site where the customer will NEVER allow a 3PAR SP
to access the public internet. Thus the SP public interface will be used
only to access and monitor the 3PAR InServ attached to this SP.
Is this a Secure Site? ( yes or no ) [no]
yes
4. Type 1 to assign SP Mode option for file transfer/remote operations and press ENTER.
Type of transport control
Enter Control-C at any time to abort this process
You have two options for file transfer/remote operations:
1 ==> SP Mode where inbound/outbound access is via ssh session and control
is via the Customer Controlled Access (CCA) setting.
2 ==> Secure Network Mode where inbound/outbound access is via https and
is controlled by the 3PAR Secure Service Agent(SSAgent).
X None of the above. Cancel and Exit
Please enter your selection [X]:
1
NOTE: Secure Network Mode can not be enabled through Secure Site setup.
5. Type 1 to continue with the SPMOB and press ENTER.
Type of install
Enter Control-C at any time to abort this process
How do you want to configure this SP?
1 ==> Continue with spmob ( new site install )
2 ==> Restore from a backup file ( SP rebuild/replacement )
X None of the above. Cancel and Exit
1
140 Initializing the Storage System Software