HP 3PAR T-Class Installation and Deinstallation Guide

7. Accept the default service processor name (in brackets) by pressing ENTER, or type an alternate
name and press ENTER. The default service processor name is the SPID. Accepting the default
is recommended.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the host name [SPXXXXX]:
[enter]
8. Type the static IP address assigned to the service processor and press ENTER.
NOTE: Even though all external communication occurs through a modem for this service
processor connection type, it is still necessary to configure the public network interface for
service processor-to-storage system communications.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the IP address for the public network interface:
<static.IP.address>
9. Press ENTER to accept the default subnet mask, or type an alternate subnet mask for the service
processor and press ENTER.
Please enter the netmask for this interface [255.255.255.0]:
<subnet.mask.address>
10. Press ENTER to accept the default gateway address shown in brackets, or type a default
gateway address and press ENTER. The setup script suggests a default gateway address based
on the IP address you have supplied. If a gateway address is unavailable, type none and
press ENTER.
Please enter the IP address of a default gateway, or NONE [<static.IP.address.1>]:
<default.gateway.address>
NOTE: If you do not specify a gateway address, the service processor must be on the same
subnet as the storage system.
11. Type no to not allow inbound and/or outbound files transfers and press ENTER.
Will this ethernet interface be used for inbound and/or
outbound files transfers (yes or no) [no]?
[enter]
134 Initializing the Storage System Software