HP 3PAR T-Class Installation and Deinstallation Guide

3. Type no to indicate the site is not secured and press ENTER.

CAUTION: If you answer yes, the service processor will not be able to communicate with

HP Central. A complete rebuild of the SP is required if the SP needs to establish communication

link with HP Central.

Site Security Level

Enter Control-C at any time to abort this process

A Secure Site is a site where the customer will NEVER allow a 3PAR SP

to access the public internet. Thus the SP public interface will be used

only to access and monitor the 3PAR InServ attached to this SP.

Is this a Secure Site? ( yes or no ) [no]

[enter]

4. Type 1 to assign SP Mode option for file transfer/remote operations and press ENTER.

Type of transport control

Enter Control-C at any time to abort this process

You have two options for file transfer/remote operations:

1 ==> SP Mode where inbound/outbound access is via ssh session and control

is via the Customer Controlled Access (CCA) setting.

2 ==> Secure Network Mode where inbound/outbound access is via https and

is controlled by the 3PAR Secure Service Agent (SSAgent).

X None of the above. Cancel and Exit

Please enter your selection [X]:

NOTE: Secure Network Mode can not be enabled through modem setup.

5. Type 1 to continue with the SPMOB and press ENTER.

Type of install

Enter Control-C at any time to abort this process

How do you want to configure this SP?

1 ==> Continue with spmob ( new site install )

2 ==> Restore from a backup file ( SP rebuild/replacement )

X None of the above. Cancel and Exit

6. Type No to retain the current value or enter the current value of the Service Processor ID (SPID)

if applicable and press ENTER.

Do you need to change the Service Processor Id (SPID)

from its current value of SPXXXXX?

(y or n)

Setting up the Service Processor 133