HP 3PAR T-Class Installation and Deinstallation Guide

28. Press ENTER to conclude MOB configuration.
InServ configuration is no longer done during the Moment Of Birth.
Use spmaint to install the InForm OS software on the SP
and add the InServ configuration to the SP after a successful MOB.
Press ENTER to continue.
NOTE: After completing the SPMOB process, additional InForm OS files must first be installed
in order to communicate and add a storage system. To install InForm OS files, refer to “Installing
HP 3PAR OS Files” (page 145).
NOTE: To add a cluster after installing HP 3PAR InForm OS files, refer to “Adding a Storage
System to the Service Processor” (page 146).
29. Monitor the system while the service processor uses the site key. When the system configuration
process is complete, the following message appears:
(....)
Config complete for <storage.system.IP.address>...
Welcome to the 3PAR Service Processor Moment of Birth
The service processor automatically restarts.
Welcome to the 3PAR Service Processor Moment of Birth
Rebooting....
Continue on to “Installing HP 3PAR OS Files” (page 145).
Modem Setup
Use the following procedure to set up the service processor at a site where a serial modem
connection is used for external communications. Remote control of the service processor may or
may not be permitted, but when permitted, also occurs through a serial modem connection using
a customer-supplied dialup number.
1. Connect the maintenance PC to the service processor through a serial connection, as described
in “Connecting to the Service Processor” (page 193), then power on the service processor and
log in as the root user.
2. Type yes to begin the service processor setup script (SPMOB) and press ENTER.
Welcome to the 3PAR Service Processor Moment of Birth
Enter Control-C at any time to abort this process
Are you ready to configure the SP at this time? (yes or no) [yes]:
[enter]
132 Initializing the Storage System Software