HP 3PAR T-Class Installation and Deinstallation Guide

20. Type the external NTP server address (if available) and press ENTER. If unavailable, type none
and press ENTER.
Network Time Server
Enter Control-C at any time to abort this process
Please enter the I/P address of an external NTP server,
or a blank delimited list if more than one is desired,
or 'none' if there will not be any time server [?]:
Enter the IP address of an external NTP server
<NTP.server.address>
21. Type yes to verify the supplied network information and press ENTER. Screen content varies
according to the chosen setup options.
SP Network Parameters
Enter Control-C at any time to abort this process
The Host Name is: <spname>
The IP address entered is: <static.IP.address>
The Netmask entered is: <subnet.mask.address>
The default gateway is: <default.gateway.address>
NTP Server address: <NTP.server.address>
Data Transfer media: ETHERNET
Remote Operations media: MODEM
Connection Server <3PAR default server> OR <server_name>
IP: <PPPD.server.IP>
Router: <phone_number>
The SP local number is: <splocalnumber>
The dialup prefix is: <prefix>
Is this data correct? (yes or no)? [yes]
[enter]
NOTE: The connection server IP and router number only appear when you are not using the
HP 3PAR Connection Server.
22. Set up the time zone for the operating site:
a. Select a country from the list, type the corresponding number <X> , and press ENTER.
b. Select a continent or ocean from the list, type the corresponding number <X> , and press
ENTER.
c. Select a country from the region list, type the corresponding number <X> , and press
ENTER
d. Select a time zone region from the list, type the corresponding number <X> , and press
ENTER
23. Verify the time zone setting is correct, type 1 and press ENTER. Choosing option 2 restarts the
time zone configuration.
24. Press ENTER to accept the default date in brackets, or type the current date in MM/DD/YYYY
format and press ENTER.
Basic Date and Time
Enter Control-C at any time to abort this process
130 Initializing the Storage System Software