HP 3PAR T-Class Installation and Deinstallation Guide

- Sequence to disable call waiting (ex. #70)
- When more then one sequence is required you may
have to insert one,
<prefix>
16. To use the HP 3PAR Connection Server, press ENTER, or type yes and press ENTER and then
skip to step 20.
To specify an alternate connection server, type no , press ENTER, and continue to step 17.
Will this SP use the 3PAR Connection Server? ( yes or no ) [yes]
[enter]
17. If you answered no in step 16, type the host name for an alternate connection server and
press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the fully qualified hostname for the Connection Server
(use only alpha numeric or . - _)- or - QUIT to abort
<server_name>
18. Type the connection server PPPD server IP address and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Enter the Connection Server's dialup (PPPD) server IP address.
Select it to be in one of following private networks IP ranges.
Note: This adress MUST be the same as specified on the Connection Server,
using the ModemConfig command.
10.0.0.0 --> 10.255.255.255
172.16.0.0 --> 172.31.255.255
192.168.0.0 --> 192.168.255.255
<PPPD.server.IP.address
>
19. Type the connection server phone number(s), including area code, and press ENTER.
Please enter Connection Server phone number(s), including area code,
using only the following characters: 0-9 ( ) - ,
Ex: 1-510-555-1212 011 813 555 12123
If there are more than one(1) phone numbers then separate them with a
colon(:)
<phone_number
>
Setting up the Service Processor 129