HP 3PAR T-Class Installation and Deinstallation Guide

Enter the IP address of an external NTP server
<NTP.server.address>
36. Type yes to configure the SP firewall in permissive mode and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
The SP firewall protects the SP and the customer network from unauthorized use.
It can be configured in ‘permissive’ mode to allow any host to connect to the SP
via SSH and HTTP.
Do you wish to configure the SP firewall in ‘permissive’ mode? [yes/no][yes]
yes
NOTE: Configuring the SP firewall in permissive mode enables access to the SP from any
host on the local area network. When Secure Network Mode is enabled, only the customer
may alter the permissive firewall setting.
37. Type yes to verify the supplied network information and press ENTER. Some items only appear
when applicable so the screen content can differ according to the chosen setup options.
SP Network Parameters - Confirmation
Enter Control-C at any time to abort this process
The Host Name is: <spname>
- Domain name: Company Name or IP Address
- Public IP address: <static.IP.address>
- Netmask: <subnet.mask.address>
- Gateway: <default.gateway.address>
- Network Speed: AUTO
DNS Server(s): <static.IPv4.address>
3PAR Secure Service Agent transport control selected.
PERMISSIVE FIREWALL MODE SELECTED
NTP Server address: none
3PAR Secure Service Collector Server
- Name/address: Production
- Proxy: none
3PAR Secure Service Policy Manager
- Name/address: <static.IP.address>
- Port: 8080
- Proxy: none
Is this data correct? (yes or no)? [yes]
yes
38. Set the time zone for the operating site:
a. Select a continent or ocean, type the corresponding number <X> , then press ENTER.
b. Select a country from the regional list, type the corresponding number <X> , then press
ENTER
c. Select a time zone region, type the corresponding number < X >, then press ENTER.
Setting up the Service Processor 123