HP 3PAR T-Class Installation and Deinstallation Guide

Enter Control-C at any time to abort this process
How do you want to configure this SP?
1 ==> Continue with spmob ( new site install )
2 ==> Restore from a backup file ( SP rebuild/replacement )
X None of the above. Cancel and Exit
1
6. Type No to retain the current value or enter the current value of the Service Processor ID (SPID)
if applicable and press ENTER.
Do you need to change the Service Processor Id (SPID)
from its current value of SPXXXXX?
(y or n)
n
7. Press ENTER to accept the default service processor name (in brackets) or type an alternate
name and press ENTER. The default service processor name is the SPID. Accepting the default
is recommended.
SP Network Parameters
Enter Control-C at any time to abort this process
Valid characters are [a-z] [A-Z] [0-9] dash(-) underscore(_)
Please enter the host name [SPXXXXX] :
[enter]
8. Type the static IP address assigned to the service processor and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the IP address for the public network interface:
<static.IP.address>
9. Press ENTER to accept the default subnet mask, or type an alternate subnet mask for the service
processor and press ENTER.
Please enter the netmask for this interface [255.255.255.0]:
<subnet.mask.address>
10. Press ENTER to accept the default gateway address shown in brackets, or type an alternate
default gateway address and press ENTER. The setup script suggests a default gateway address
based on the supplied IP address.
Please enter the IP address of a default gateway, or NONE [<static.IP.address.1>]:
<default.gateway.address>
118 Initializing the Storage System Software