HP 3PAR T-Class Installation and Deinstallation Guide

10. Press ENTER to accept the default gateway address shown in brackets, or type an alternate
default gateway address and press ENTER. The setup script suggests a default gateway address
based on the supplied IP address.
Please enter the IP address of a default gateway, or NONE [<static.IP.address.1>]:
<default.gateway.address>
11. Press ENTER to accept the default network speed or enter the network speed and press ENTER.
Please enter the network speed (10HD,10FD,100HD,100FD,1000HD,1000FD,AUTO)
[AUTO]
12. Type yes to allow inbound and/or outbound files transfers and press ENTER.
Will this ethernet interface be used for inbound and/or
outbound files transfers (yes or no) [no]?
yes
13. For technical support and services through a remote location, press ENTER, or type yesand
press ENTER.
To prohibit remote control of the service processor, type no and press ENTER, then skip to step
15.
SP Network Parameters
Enter Control-C at any time to abort this process
Will this SP be allowed to be remotely controlled (yes or no)? [yes]
(Replying 'yes' will allow Remote Operations sessions from a Connection
Portal)
yes
14. To use the customer network to access the service processor from a remote location, type e
and press ENTER
Which media will be used for Remote Operations ( ethernet or modem )?
Enter 'e' or 'm' [modem]
e
15. To use the 3PAR Connection Portal, type yes or press ENTER, and skip to step 17.
To assign an alternate connection server, type no press ENTER and continue with step 16.
SP Network Parameters
Enter Control-C at any time to abort this process
Will this SP use the 3PAR Connection Portal? ( yes or no ) [yes]
yes
112 Initializing the Storage System Software