HP 3PAR T-Class Installation and Deinstallation Guide

Please enter your selection [X]:
1
5. Type 1 to continue with the SPMOB and press ENTER.
Type of install
Enter Control-C at any time to abort this process
How do you want to configure this SP?
1 ==> Continue with spmob ( new site install )
2 ==> Restore from a backup file ( SP rebuild/replacement )
X None of the above. Cancel and Exit
1
6. Type No to retain the current value or enter the current value of the Service Processor ID (SPID)
if applicable and press ENTER.
Do you need to change the Service Processor Id (SPID)
from its current value of SPXXXXX?
(y or n)
n
7. Press ENTER to accept the default service processor name (in brackets) or type an alternate
name. The default service processor name is the SPID. Accepting the default is recommended.
SP Network Parameters
Enter Control-C at any time to abort this process
Valid characters are [a-z] [A-Z] [0-9] dash(-) underscore(_)
Please enter the host name [SPXXXXX] :
[enter]
8. Type the static IP address assigned to the SP and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the IP address for the public network interface:
<static.IP.address>
9. Press ENTER to accept the default subnet mask, or type an alternate subnet mask for the SP
and press ENTER.
Please enter the netmask for this interface [255.255.255.0]:
<subnet.mask.address>
Setting up the Service Processor 111