HP 3PAR T-Class Installation and Deinstallation Guide
1. Wait for one minute
2. Click the Retry button.
High Speed Setup
Use the following procedure to set up the SP at a site where an Ethernet connection to the customer
network is used to monitor the storage system and for all external communications with the service
processor. Remote control of the service processor may or may not be permitted. If permitted you
must also use the customer network.
Configuring the SP with SP Mode
NOTE: Before performing the SPMOB, always reference the Systems Assurance form for details
of customer network setting requirements.
1. Connect the maintenance PC to the service processor through a serial connection, as described
in “Connecting to the Service Processor” (page 193), then power on the service processor and
log in as the root user.
2. Type yes to begin the service processor setup script (SPMOB) and press ENTER.
Welcome to the 3PAR Service Processor Moment of Birth
Enter Control-C at any time to abort this process
Are you ready to configure the SP at this time? (yes or no) [yes]:
[enter]
3. Type no to indicate the site is not secured and press ENTER.
CAUTION: If you answer yes, the service processor will not be able to communicate with
HP Central. A complete rebuild of the SP is required if the SP needs to establish communication
with HP Central.
Site Security Level
Enter Control-C at any time to abort this process
A Secure Site is a site where the customer will NEVER allow a 3PAR SP
to access the public internet. Thus the SP public interface will be used
only to access and monitor the 3PAR InServ attached to this SP.
Is this a Secure Site? ( yes or no ) [no]
[enter]
4. Type 1 to assign SP Mode for file transfer/remote operations and press ENTER.
Type of transport control
Enter Control-C at any time to abort this process
You have two options for file transfer/remote operations:
1 ==> SP Mode where inbound/outbound access is via ssh session and control
is via the Customer Controlled Access (CCA) setting.
2 ==> Secure Network Mode where inbound/outbound access is via https and
is controlled by the 3PAR Secure Service Agent (SSAgent).
X None of the above. Cancel and Exit
110 Initializing the Storage System Software