HP 3PAR Storage Replication Adapter 5.1.0 Troubleshooting Guide

Table 21 Message Table (continued)
Fix HintMessage DescriptionName
3PAR_2010
• If the error is caused by insufficient privilege to
issue the command, contact your storage
administrator for assistance.
• If the error is related to network issues, check if you
have problem with your network connection.
• If you have firewall or anti-virus software installed
on the system, make sure it allows network access
to the HP 3PAR Storage system.
Warning. Unable to get DR state
information for Remote Copy Group
<GroupName>.
3PAR_2011
• If the error is caused by insufficient privilege to
issue the command, contact your storage
administrator for assistance.
• If the error is related to network issues, check if you
have problem with your network connection.
• If you have firewall or anti-virus software installed
on the system, make sure it allows network access
to the HP 3PAR Storage system.
This might be a result of the previous failover operation
from SRM or a manual failover operation on the HP
3PAR Storage system.
Warning. Remote Copy link for
replication target <TargetName> is
down. Data is not in sync.
3PAR_2012
SRA is unable to start the replication process after the
disruptive test failover operation. Access your HP 3PAR
Warning. Unable to start the replication
process. Additional information:
<ExceptionString>
3PAR_2013
Storage system for more detailed information on the
current status of the Remote Copy group.
Make sure the SRM specified log folder is accessible.Warning. Unable to access the specified
log folder. The log file will be available
at the following location: <LogPath>.
3PAR_2014
SRA will retry the connection again.Warning. Connection has the following
problem: <ConnProblem>. Retry again.
3PAR_2015
HP 3PAR Remote Copy Software only supports group
replication.
Warning. 3PAR SRA only supports group
replication.
3PAR_2016
SRA does not support group name that contains
<xxx>.r<xxx>.
Warning. Group name <GroupName>
has unsupported naming convention.
3PAR_2017
Snapshot is not created according to the specification
to support recovery point.
Warning. Recovery point information is
not available.
3PAR_2018
The Remote Copy group can be in an invalid SRA
state after reinstalling or reconfiguring the SRM setting
Warning. Remote Copy group
<GroupName> is in invalid SRA state.
3PAR_2019
after failover. Refer to the SRA Implementation Guide
for how to reset the SRA state to this group.
This is the result of having one protected group
spanning across multiple Remote Copy groups. This
Warning. Configuration with more than
one Remote Copy group per protected
group is not a recommended setup.
3PAR_2020
is not a recommended setup. To resolve this issue,
make sure all the volumes used in one protected group
comes from the same Remote Copy group.
None.Info. Remote Copy Group {0} is currently
having {1} role under {2} state.
3PAR_3001
None.Info. Remote Copy Group
<GroupName> has been stopped
remotely.
3PAR_3002
None.Info. Remote Copy target <TargetName>
mirroring configuration has been
disabled.
3PAR_3003
125