3PAR Storage Replication Adapter for VMware vCenter Site Recovery Manager 5.0 Implementation Guide

Initial Setup for Remote Copy from the Recovery Site.
1. From the recovery site (s159 in the following examples) set up the Gigabit Ethernet link.
root@snodec242:~# controlport rcip addr -f 10.100.33.230 255.255.255.0 0:6:1
Remote Copy interface change successful.
root@snodec242:~# controlport rcip addr -f 10.101.33.230 255.255.255.0 1:6:1
Remote Copy interface change successful.
root@snodec242:~# controlport rcip gw -f 10.100.33.1 0:6:1
Remote Copy interface change successful.
root@snodec242:~# controlport rcip gw -f 10.101.33.1 1:6:1
Remote Copy interface change successful.
2. Verify connectivity (s159).
root@snodec242:~# showport -rcip
N:S:P State ---HwAddr--- IPAddr Netmask Gateway MTU Rate Duplex
AutoNeg
0:6:1 ready 0002AC530160 10.100.33.230 255.255.255.0 10.100.33.1 1500 1Gbps
Full Yes
1:6:1 ready 0002AC530243 10.101.33.230 255.255.255.0 10.101.33.1 1500 1Gbps
Full Yes
------------------------------------------------------------------------------------------
2
Setting up Remote Copy Targets and Links
1. Set up Remote Copy targets and links on the protected site.
root@inodee2023:~# startrcopy
root@inodee2023:~# creatercopytarget s230 IP 0:10.100.33.230 1:10.101.33.230
root@inodee2023:~# showrcopy links
Remote Copy System Information
Status: Started, Normal
Link Information
Target Node Address Status Options
s230 0 10.100.33.230 Up
s230 1 10.101.33.230 Up
receive 0 receive Up
receive 1 receive Up
2. Set up Remote Copy targets and links on the recovery site.
root@snodec242:~# startrcopy
root@snodec242:~# creatercopytarget s388 IP 0:10.100.33.88 1:10.101.33.88
root@snodec242:~# showrcopy links
Remote Copy System Information
14 HP 3PAR Storage System Setup