3PAR Replication Adapter 4.0.1 for VMware vCenter Site Recovery Manager Implementation Guide

17
HP 3PAR Storage System Setup
HP 3PAR Replication Adapter 4.0.1 for VMware Site Recovery Manager Implementation Guide
3 Set up Remote Copy targets and links (s230).
8.2.2 Initial Setup for Remote Copy from the Recovery Site.
1 From the recovery site (s159 in the following examples) set up the Gigabit Ethernet link.
2 Verify connectivity (s159).
startrcopy
creatercopytarget s159 IP 0:6:1:10.100.33.159 1:6:1:10.101.33.159
root@snodec161:S230# showrcopy links
Remote Copy System Information
Status: Started, Normal
Link Information
Target Node Address Status Options
s159 0:6:1 10.100.33.159 Down
s159 1:6:1 10.101.33.159 Down
receive 0:6:1 receive Up
receive 1:6:1 receive Up
controlport rcip addr 10.100.33.159 255.255.255.0 0:2:1
controlport rcip addr 10.101.33.159 255.255.255.0 1:2:1
controlport rcip gw 10.100.33.1 0:2:1
controlport rcip gw 10.101.33.1 1:2:1
controlport rcip mtu 1500 0:2:1
controlport rcip mtu 1500 1:2:1
controlport rcip speed auto 0:2:1
controlport rcip speed auto 1:2:1
showport -rcip
N:S:P State ---HwAddr--- IPAddr Netmask Gateway MTU Rate Duplex AutoNeg
0:2:1 ready 000423E009D9 10.100.33.159 255.255.255.0 10.100.33.1 1500 1Gbps Full Yes
1:2:1 ready 000423E009DC 10.100.33.159 255.255.255.0 10.100.33.1 1500 1Gbps Full Yes