HP 3PAR StoreServ 7000 Storage Installation Guide

E Validating Remote Support
After making any networking changes or if the Service Processor Setup Wizard is unable to verify
remote support connectivity, use the SPMaint module in SPOCC to test the communication with
remote support.
NOTE: For a current list of supported browsers for SPOCC, see the Single Point of Connectivity
Knowledge for HP Storage Products (SPOCK), located at http://www.hp.com/storage/spock.
1. Open a supported type of web browser. Enter the SP IP address (https://<SP_IP>) to log on
to SPOCC.
Figure 96
2. Enter your login credentials. Click Log In.
3. Click SPmaint.
Figure 97 SPOCC Support Page
4. Click Network Configuration.
Figure 98 SPOCC Network Configuration Page
100 Validating Remote Support