HP 3PAR Peer Motion Guide

• Create the fourth zone, Z4 with Host HBA (HBA1) zoned to host ports of destination
• Save and enable the config with Z1, Z2
Installing the HP 3PAR Peer Motion Utility
System Requirements
The following are operating system requirements:
Software
HP 3PAR Peer Motion Utility can be installed and run on:
• Windows 2008/R2, Windows 2012/R2 (both server and client), components of HP 3PAR
PMU can be installed
• Windows 7/8/8.1 (both server and client), components of HP 3PAR PMU can be installed
• RHEL 5.5, 5.6, 5.7, 5.8, 5.9, 5.10, 6.1, 6.2, 6.3, 6.4, 6.5 (only client)
NOTE: If you are using RHEL 6.3 or earlier, you must update Java to 7.0 version.
For more information on the supported operating systems, see the Support Matrix on SPOCK at
http://www.hp.com/storage/spock.
NOTE: HP 3PAR Peer Motion Utility server runs only on a Windows system
Hardware
The following are the hardware requirements for installing HP 3PAR Peer Motion Utility:
• Multi-core processor
• 2GB space must be available on the hard drive for installation
• Minimum of 512 MB of free RAM must be available on the system
Installation on a Windows System
Use the following procedures to install the HP 3PAR Peer Motion Utility on a Windows system.
Download the HP 3PAR Peer Motion Utility.exe at the software portal at:
http://www.software.hp.com
To install on Windows:
1. Double-click the installer and in the Welcome screen, click Next.
Installing the HP 3PAR Peer Motion Utility 61