HP 3PAR Peer Motion Guide

Figure 2 Interlinking source and destination arrays
• To interlink the arrays, two FC ports are configured as peer ports on the destination array and
hooked up via the SAN to host ports on the source array. The peer ports must be created on
horizontally adjacent nodes on the destination array. On the source array, the host ports do
not need to be on horizontally adjacent nodes, but should be on different nodes. You can
create peer ports in HP 3PAR Management Console or use the CLI command, controlport.
• The ports for the array interlinks (blue lines) on the source array are standard host ports. They
can even be host ports that are already in use by a host.
• Direct FC connect between destination arrays is not supported.
10 Overview of HP 3PAR Peer Motion