HP 3PAR VMware ESX Implementation Guide

5. Click the Properties tab.
6. Select the General tab.
7. Click Configure...
8. Select the Enabled check box for the status.
9. Click OK.
10. Click the Dynamic Discovery tab. Dynamic discovery enables the Send Targets discovery
method, where the initiator sends the request to discover and log into the targets:
Figure 39 Send Targets
11. Click Add....
12. Enter the IP address of one of the previously defined HP 3PAR StoreServ Storage iSCSI ports.
13. Click OK.
14. Add additional HP 3PAR StoreServ Storage iSCSI ports if they exist and have been defined
on the system:
Figure 40 Adding Additional iSCSI Ports
72 Configuring the Host for an iSCSI Connection