HP 3PAR VMware ESX Implementation Guide

Figure 11 CN1100E BIOS
4. Make sure that your CNA is not configured for Independent Hardware iSCSI.
NOTE: These steps are specific to the CN1100E. Different vendors employ different methods
of implementing Dependent Hardware iSCSI. See vendor documentation for specific procedures.
a. On the CN1100E, press Ctrl+S to enter the BIOS.
b. Select Controller Configuration.
c. Select your controller port.
d. Select Erase Configuration, as shown in Figure 12 (page 27):
Figure 12 Erase Configuration
5. When the ESXi host is booted, in vCenter, select your host and then click the Configuration
tab.
6. Click Network Adapters and verify that the CNA is present:
Hardware iSCSI Support 27