HP 3PAR StoreServ 7450 Storage Troubleshooting Guide

Port Example 2
Component -Description- Qty
Port Missing SFPs 1
Component -Identifier- -Description--
Port port:0:3:1 SFP is missing
Port Suggested Action 2
FC node-ports that normally contain SFPs will report an error if the SFP has been removed. The
condition can be checked using the showport -sfp command. In this example, the SFP in 0:3:1
has been removed from the adapter:
cli% showport -sfp
N:S:P -State- -Manufacturer- MaxSpeed(Gbps) TXDisable TXFault RXLoss DDM
0:0:1 OK FINISAR_CORP. 2.1 No No No Yes
0:0:2 OK FINISAR_CORP. 2.1 No No No Yes
0:3:1 - - - - - - -
0:3:2 OK FINISAR_CORP. 2.1 No No No Yes
Port Example 3
Component -Description- Qty
Port Disabled SFPs 1
Component -Identifier- --Description--
Port port:3:5:1 SFP is disabled
Port Suggested Action 3
A node-port SFP will be disabled if the port has been placed offline using the controlport
offline command. Also see Example 4.
cli% showport -sfp
N:S:P -State- -Manufacturer- MaxSpeed(Gbps) TXDisable TXFault RXLoss DDM
3:5:1 OK FINISAR_CORP. 4.1 Yes No No Yes
3:5:2 OK FINISAR_CORP. 4.1 No No No Yes
Port Example 4
Component -Description- Qty
Port Offline ports 1
Component -Identifier- --Description--
Port port:3:5:1 is offline
Port Suggested Action 4
Check the state of the port with showport. If a port is offline, it was deliberately put in that state
using the controlport offline command. Offline ports may be restored using controlport
rst.
cli% showport
N:S:P Mode State ----Node_WWN---- -Port_WWN/HW_Addr- Type
3:5:1 target offline 2FF70002AC00054C 23510002AC00054C free
Troubleshooting Storage System Components 51