HP 3PAR StoreServ 7450 Storage Installation Guide

Figure 52 Generating SP ID Page
NOTE: During the SP Setup process, the StoreServ must be powered on, connected to the
same network subnet as the SP, and non-initialized to allow the SP to verify the StoreServ
serial number.
3. After the SP ID is generated, click Next.
Configure SP Networking
To complete this section, use the completed installation checklist from HP 3PAR StoreServ 7450
Site Planning Manual as reference.
NOTE: For additional information and help, use the HP 3PAR SmartStart online help (accessible
by pressing F1).
1. Enter the SP information for the following fields:
• Service Processor hostname
• IP Address
• Subnet Mask
• Gateway
Launching the HP 3PAR Service Processor Setup Wizard 63