HP 3PAR StoreServ 7450 Storage Installation Guide

Removing the Brackets
Remove the cable restraint shipping brackets only when the cabinet is in its final location.
1. Remove the data cables from the hook and loop straps.
2. Loosen the captive screws (see Figure 16 (page 21).
Figure 16 Loosening the Captive Screws
3. Remove the brackets. Be careful not to damage the attached data cables.
Now continue on to “Verifying Setup and Powering On the Storage System” (page 42) and verify
setup before powering on the storage system and initializing the SP and storage system software.
Installing and Removing the Cable Restraint Shipping Brackets 21